Robocho Join free
Robots Parts GNSS-RTK L1/L5 Breakout - NEO-F9P (Qwiic)

SparkFun Electronics

GNSS-RTK L1/L5 Breakout - NEO-F9P (Qwiic)

Other partResearchHobby

Watch: changes show on your home page, plus one email a day at most when a fact, listing or review changes.

A GNSS receiver breakout board built around the u-blox NEO-F9P module, receiving L1 and L5 bands for RTK positioning.

Specs

SpecValueSource
GNSS chipu-blox NEO-F9Psparkfun.com
ConstellationsGPS, GLONASS, Galileo, BeiDousparkfun.com
Frequency bandsL1/L5sparkfun.com
RTK accuracy0.01 msparkfun.com
Update rate25 Hzsparkfun.com
InterfaceUART, I2Csparkfun.com
Supply voltage5 or 3.3 Vsparkfun.com
Show the exact words from each source
  • GNSS chip: “brings the power of the u-blox NEO-F9P engine to your project” sparkfun.com
  • Constellations: “Concurrent reception of GPS, GLONASS, Galileo and BeiDou” sparkfun.com
  • Frequency bands: “Receives L1/L5 Bands” sparkfun.com
  • RTK accuracy: “Achieves ~10mm 3D accuracy when used as an RTK rover.” sparkfun.com
  • Update rate: “Supports a max navigation rate of 25Hz (RTK, PVT, and RAW)” sparkfun.com
  • Interface: “Supports NMEA, UBX, RTCM, SPARTN, CLAS protocols over UART or I2C interfaces” sparkfun.com
  • Supply voltage: “Voltage: 5V or 3.3V but all logic is 3.3V” sparkfun.com

Price and where to buy

US$259.95 price on the maker store, seen 2026-11-10. Source

Robocho sells nothing and earns nothing from these links or requests.

Compare with

Other part

Arduino

BugHopper

  • USB-to-UART bridgeFTDI FT230XQ-R
  • Target boardUNO Q (via JCTL 2.54 mm connector)
  • USB connectorUSB-C
Other part

Arduino

Ethernet Shield 2

  • Ethernet controllerW5500
  • Connection speed10/100 Mb
  • Operating voltage5 V

Owner reviews

No reviews yet.

Write a review Free profile.